CS series cone crusher and its parts

CS series cone crusher is earlier cone crusher, and now is still widely used in mining industry. It is mainly used in fine crushing process to crush mid-hard rocks and ores, such as iron ores, copper ores, limestone, quartz, granite, gritstone, etc in mining industry, concrete factory, sandstone making.

Generally, primary gyratory crushers produce a more cubical product in comparison to a jaw crusher. The additional advantages are:

1. Permit use of smaller discharge settings.
2. Capacities are considerably higher, particularly in the range of finer settings.
3. Wear is more evenly distributed in the lower part of the crushing chamber.
4. Ratio of reduction is higher, averaging 8 to 1.

To accurately apply a primary gyratory crusher, it is essential to obtain rock samples for fest work. The results of this test work will aid in the horsepower recommendation, eccentric, throw, and recommended open side setting.

Maintenance Items:

1. Gyratory crusher pre-fitted concave liner platforms can provide rapid concave replacement if pre hung on installation platforms. Chipping off existing concaves and letting them fall to the surge bin below facilitates the installation of new concaves. Remove old concaves from the surge bin at the same time as new concaves are being installed.
2. Provide air hammer support (spider bolt removal) from a circular monorail.
3. Pull points should be located in a manner that provides maximum assistance for equipment maintenance.
4. Provide a hoist and trolley for lifting the crusher and feeder motors.
5. A man-elevator is always useful in a gyratory crusher plant, but is often eliminated to reduce capital costs. Provisions should be made for installing one at a later date.
6. Service air and water stations should be located throughout the plant. Include hoses and nozzles at predetermined washdown stations.

Contact e-mail service@unisbm.net
Attachments:
CS series cone crusher pdf download