Impact Crusher work notice and problems solution

Impact Crusher is a new and efficient stone crusher machine. Absorbing advanced technologies at home and abroad ang on the basic oif hammer crusher, it has been designed. Impact crusher has been widely used in the cement industry. It is mainly used to crusher limestone, sandstone, etc, Whose side is 500mm length, anti-pressure strength is not more than 350Mpa. Our impact crusher is characterized by great reduction ratio, high reduction efficiency, convenient maintenance, etc. The final product is in the shape of a cube.

Impact Crusher Work Notice

Impact Crusher is a important crusher equipment in stone crusher line, in the process of using the crusher, firstly pay attention to the safe operation:

1. When the impact crusher machine operating, the staff can not stand within the role of inertial forces, electrical switch installation should avoid this location.
2. When machine is running, strictly forbid to open the observation door to check the situation, strictly prohibit any adjustment, cleaning, maintenance, etc. to avoid danger.
3. strictly prohibited pour the material can not be broken into the impact crusher in order to avoid damage to the machine.
4. When the impact crusher is in overhaul, the first is to cut off the power.
5. prohibite work overload
6. electrical equipment should be grounded, insulated wire should be reliable, and packed in snakeskin tube.

In the work process, pay special attention to what happen as follows:

• A.the bearing temperature is too high

  Solution:

  1. First, check whether the grease is reducing;
  2. Standard terms of bearing grease should be filled with volume 50%;
  3. timely clean bearings, replace grease;
  4. If badly worn, replace the bearings.
• B.In operation process, crushing chamber internally generated percussion sound very keen.

  solution:

  1. immediately turn off the power, and clean up the crushing chamber to check whether there are the material that can not be broken.
  2. Check the lining of the fastening conditions and the gap between the hammer and the liner; whether the wear-resistant lining is shed.
  3. Replace the broken machine
• C.The final size of impact crusher is too large.

solution:

1. adjuste the gap between before and after the frame, or replace the worn grave liner and board hammer;
2. adjust position of the counter-attack planes

Contact e-mail service@unisbm.net
Attachments:
Impact crusher pdf download